新闻资讯

公司与国内知名房产单位以及各大建筑单位建立了良好的合作关系,是目前国内专业的金属、PVC落水系统解决专家

  • 新旧天沟更替的方法
  • 本站编辑:杭州得裕建材有限公司发布日期:2020-01-05 08:27 浏览次数:

落水系统中的一个重要组成部分就是天沟,使用一段时间后就可能坏掉,因此需要及时的检修,否则在清除旧排水天沟的时候会造成一定的破坏。

1、当旧排水天沟在地上时,将其正确地排列成直线,并要求有大量的新排水沟与其平行放置。

2、对新排水天沟进行标记,并将其切成适当尺寸的片段。

3、用木工尺来标记切线。

4、用钢锯或带金属切割刀片的电锯来切割金属落水系统中的排水天沟,对边缘进行锉口,并在切口表面涂刷防锈剂。

5、用带有锋利锯齿的手锯来切割塑料排水天沟。

6、为了防止切割排水沟时排水沟壁变软,可将木材填料填充到排水天沟里,并使其尽可能接近切口位置。

7、切割完成后,对粗糙的边缘进行整理。

8、新排水天沟安装之前,先检查封檐板是否发生腐蚀。

9、如果有损坏,要及时更换。

10、将排水天沟落水系统的末端放置于封檐板的最低点处。

在屋面排水过程中,所使用的天沟都会出现一些问题,对于天沟的更新就可确保整个落水系统的正常排水。可见天沟在屋面落水系统中的重要性。

The gutter is an important part of the drainage system. It may break down after a period of use. Therefore, it needs to be repaired in time, otherwise it will cause some damage when the old gutter is cleared. 1. When the old drainage gutter is on the ground, align it correctly and require a large number of new drains to be placed parallel to it. 2. Mark the new drainage gutter and cut it into sections of appropriate size. 3. Use a carpenter's rule to mark the tangents. 4. Use a hacksaw or an electric saw with a metal cutting blade to cut the gutter in the metal downspout, file the edges, and brush the surface with a rust inhibitor. 5. Use a hand saw with sharp teeth to cut the plastic gutter. 6. In order to prevent the wall from softening when cutting the drain, fill the gutter with wood filler and make it as close to the cut as possible. 7. After cutting, finish the rough edges. 8, the new drainage gutter installation, check whether the Cornice board corrosion. If there is damage, replace it in time. 10. Place the end of the drainage gutter drain system at the lowest point of the Cornice Board. In the process of roof drainage, there will be some problems in the gutter used. The renewal of the gutter can ensure the normal drainage of the whole drainage system. The importance of gutter in roof drainage system can be seen.

杭州得裕建材有限公司

地  址:杭州市余杭区余杭镇义桥工业园区 

手  机:13758137262 ( 乔经理 )

座  机:0571-56017206

传  真:0571-85853340